We went to Yellowstone last summer and saw everything. There was a lot of walking to the geyser basins and waiting, waiting, and waiting for the geysers to erupt. I was knitting boot socks from hand spun Romney. I had the whole knitting bag with me but one knitting sheath became the choice :
As I look at pictures of sailing this fall, there it is, always with 9" long, 2.38 mm steel DPN. I will say that on some of those sailing trips, the needles got doused with sea water, and rusted. Everything was wet for a couple of days. Still a bit of crocus cloth brought the needles back to perfect conditions in minutes.
There was a lot of sampling of series of yarns. Many of these were done on a very light weight knitting sheaths tucked into an elastic pant waist band:
As I look at pictures of sailing this fall, there it is, always with 9" long, 2.38 mm steel DPN. I will say that on some of those sailing trips, the needles got doused with sea water, and rusted. Everything was wet for a couple of days. Still a bit of crocus cloth brought the needles back to perfect conditions in minutes.
There was a lot of sampling of series of yarns. Many of these were done on a very light weight knitting sheaths tucked into an elastic pant waist band:
This one was made from redwood. The redwood is much too soft to support the small steel needles, and hence needs a hardwood adapter, maple in this case. Moreover, the redwood is too weak to hold interchangeable adapters tightly, and thus the adapter must be glued, and it is not interchangeable. Just the tool to knit yarn hot off the plying bobbin.
And the winner:
My Ashford flier with standard high speed whorl (22:1) and a bobbin with a 5/8" core and DRS of 1.017 for spinning singles in the range of 10,000 ypp. This has been a good setup for spinning singles in the 9,000 to 15,000 ypp range. It is simple, inexpensive, and it works! This rig will spin 11,200 ypp singles, faster, easier, and more consistently than any of the mass produced spinning assemblies. Only Alden Amos' flier assemblies are faster.
0 comments:
Post a Comment